“软起动柜生产厂家供应10KV高压软起动器”详细介绍
完整的CMV系列软起动装置是一个标准的电机起动、保护装置,用来控制和保护高压交流电机。标准的CMV产品主要由以下部件组成:高压可控硅模块、可控硅保护部件、光纤触发部件、真空开关部件、信号采集与保护部件、系统控制与显示部件。可控硅模块:每相中采用相同参数的可控硅串并联安装在一起。根据所使用电网的峰值电压要求,选择可控硅串联的数量不同。可控硅保护部件:主要包括由RC网络组成的过电压吸收网络、由均压单元组成的均压保护网络。光纤触发部件:采用强触发脉冲电路,保证触发的一致性和可靠性;利用光纤触发进行可靠高低压隔离。真空开关部件:在起动完成后,三相真空旁路接触器自动吸合,电动机投入电网运行。信号采集与保护部件:通过电压互感器、电流互感器、避雷器、零序电流互感器对主回路电压、电流信号进行采集,主CPU控制并进行相应保护。系统控制与显示部件:32位ARM核微控制器执行中心控制、LCD液晶\触摸屏显示,可显示三相电压、电流,故障信息、运行状态等。CMV系列的控制核心是微处理器CPU。微处理器对SCR进行相角触发控制以降低加在电机上的电压,然后通过慢慢地控制加在电机上的电压和电流平滑地增加电机转矩,直到电机加速到全速运行。这种起动方式可以降低电机的起动冲击电流,减少对电网和电机自身的冲击。同时也减少了对连在电机上机械负载装置的机械冲击,以延长设备的使用寿命,减少故障和停机检测时间。
“软起动柜生产厂家供应10KV高压软起动器”其他说明
基本参数Basic parameters | |
负载种类 Type of load |
三相高压鼠笼式异步电机、同步电机 Three-phase squirrel cage asynchronous and synchronous motors |
交流电压 AC voltage |
3000---10000VAC |
工作频率 Service frequency |
50HZ/60HZ±2HZ |
相 序 Phase sequence |
CMV允许在任何相序下工作(可通过参数设定) CMV is allowed to work with any phase sequence (through setting parameter) |
主回路组成 Composition of major loop |
(12SCRS、18SCRS、30SCRS视型号而定) (12SCRS、18SCRS、30SCRS depend on model) |
旁路接触器 Bypass contactor |
具有直接起动容量的接触器 Contactor with direct starting capacity |
控制电源 Control power |
AC220V±15% |
瞬时过电压保护 Transient voltage overload protection |
dv/dt吸收网络 dv/dt snubber network |
起动频次 Start frequency |
1—3次(每小时) 1-3 times per hour |
环境条件 Ambient condition |
环境温度:-20°C -+50°C Ambient temperature: -20°C -+50°C |
相对湿度:5%----95%无凝露 Relative humidity: 5%----95% no condensation |
|
海拔小于1500米(大于1500米需降容使用) Altitude less than 1500m (derating when altitude is more than 1500m) |
|
保护功能Protective functions | |
缺相保护 Open-phase protection |
在起动或运行过程中,断开主电源的任意相 Cut off any phase of primary power supply in the course of starting or operation. |
运行过流保护 Over-current protection in operation |
运行过流保护设定:20~500%Ie Operational Over-current protection setting: 20~500%Ie |
相电流不平衡保护 Unbalanced phase current protection |
相电流不平衡保护:0~100% Unbalanced phase current protection: 0~100% |
过载保护 Overload protection |
过载保护级别:10A、10、15、20、25、30、OFF Overload protection grade: 10A、10、15、20、25、30、OFF |
欠载保护 Underload protection |
欠载保护级别:0~99% 欠载保护动作时间:0~250S Underload protection grade: 0~99% Action time of underload protection: 0~250S |
起动超时 Start timeout |
起动时间限制:0~120S Start time limit: 0~120S |
过压保护 Over-voltage protection |
主电源电压高于额定值的120%时,过压保护 When voltage of primary power supply is 120% higher than rated value, over-voltage protection is enabled. |
欠压保护 Under-voltage protection |
主电源电压低于额定值的70%时,欠压保护 When voltage of primary power supply is 70% lower than rated value, under-voltage protection is enabled. |
相序保护 Phase protection |
允许在任何相序下工作(可通过参数设定) Allow to work with any phase sequence (through setting parameter) |
接地保护 Ground protection |
接地电流大于设定值时保护 Protection available when grounding current is higher than set value |
通讯说明Description of communication | |
通讯协议 Protocol |
Modbus RTU |
通讯接口 Communication interface |
RS485 |
网络连接 Network connection |
每台CMV可与31台CMV设备连网通讯 Each CMV can communicate with 31 CMV equipments in network. |
功 能 Function |
通过通讯接口可以观察运行状态、编程 Operation state and programming can be observed through communication interface. |
操作界面Operating interface | |
LCD显示 LCD display |
LCD(液晶)显示/触摸屏显示 LCD display/touch screen display |
语 言 Language |
中、英文 Chinese and English |
键 盘 Keyboard |
6个触摸式薄膜按键 6 touch membrane keyboard |
仪表显示Meter display | |
主电源电压 Voltage of primary power supply |
显示三相主电源电压 Display voltage of three-phase primary power supply |
三相电流 Three-phase current |
显示三相主回路电流 Display current of three-phase major loop |
数据记录Data record | |
故障记录 Fault history |
记录最近15次故障信息 Record recent 15 faults information |
起动次数记录 History of number of starts |
记录本装置的起动次数 Record number of starts of this soft starter |